The pump pulley on my compressor has some cracks on some of the blades.
In a perfect world I would replace it but a repair will have to do for now, unless anyone has a spare 280mm bladed pulley going spare?
It is made from cast iron or cast steel & the methods I have available are oxy/propane brazing, tig or stick with m/s, s/s & dissimilar metals filler rods available.
I'm leaning toward brazing but I'm open to suggestions.
In a perfect world I would replace it but a repair will have to do for now, unless anyone has a spare 280mm bladed pulley going spare?
It is made from cast iron or cast steel & the methods I have available are oxy/propane brazing, tig or stick with m/s, s/s & dissimilar metals filler rods available.
I'm leaning toward brazing but I'm open to suggestions.