Hi all,
I just thought I'd create a short post to confirm what someone else has said on this forum elsewhere, as it may help others running into the same problem...
I'm a newbie welder using a Clarke 151TE. The welder has two options for amending the power settings - a button (min / max) and a dial (1, 2 and 3). The manual states that the power should increase in the following way: Min 1, Min 2, Min 3, Max 1, Max 2, Max 3.
However, having tested the output using a voltmeter, I can also confirm that the power increments actually increase as follows: Min 1, Max 1, Min 2, Max 2, Min 3, Max 3.
Hope this is helpful for anyone else with the same welder who might be struggling with the results their getting.
Other than that, I think it's a great little machine and am very happy with its performance.
All the best
Andy
I just thought I'd create a short post to confirm what someone else has said on this forum elsewhere, as it may help others running into the same problem...
I'm a newbie welder using a Clarke 151TE. The welder has two options for amending the power settings - a button (min / max) and a dial (1, 2 and 3). The manual states that the power should increase in the following way: Min 1, Min 2, Min 3, Max 1, Max 2, Max 3.
However, having tested the output using a voltmeter, I can also confirm that the power increments actually increase as follows: Min 1, Max 1, Min 2, Max 2, Min 3, Max 3.
Hope this is helpful for anyone else with the same welder who might be struggling with the results their getting.
Other than that, I think it's a great little machine and am very happy with its performance.
All the best
Andy