liam_italian
New Member
- Messages
- 2
- Location
- caernarfon, north wales
hello everyone
I'm hoping someone here can help me diagnose the problem with my Clarke 205te.
Recently it stopped feeding wire and i suspected the motor had packed in so i fitted a few one but still no wire feed. I then fitted a new pcb board and this seems to fix it for about 5 minutes.
When trying to weld it would only feed for a few seconds before stopping, this carried on for about 10 minutes before it stopped feeding all together. I've had a look inside and I've noticed the small glass fuse has blown and also a black flat square transistor is looking a little toasted.
I would appreciate any suggestions from you all as to what might be causing this.
I'm hoping someone here can help me diagnose the problem with my Clarke 205te.
Recently it stopped feeding wire and i suspected the motor had packed in so i fitted a few one but still no wire feed. I then fitted a new pcb board and this seems to fix it for about 5 minutes.
When trying to weld it would only feed for a few seconds before stopping, this carried on for about 10 minutes before it stopped feeding all together. I've had a look inside and I've noticed the small glass fuse has blown and also a black flat square transistor is looking a little toasted.
I would appreciate any suggestions from you all as to what might be causing this.