No doubt this has been asked before but has anyone used the above on a cars/vans bodywork and how is it on it's lowest settings?
Thinking about buying one tomorrow before my VAT free offer runs out, but really cant make my mind up about it. Currently using a en90 but owning a transit I need a good welder. Is it any good for around 4mm like it says or is that a load of ****? Will it do thin stuff like 08-1.0mm without blowing holes?
If its any good for thin stuff I might bite the bullet, buy it, sell the en90
Thinking about buying one tomorrow before my VAT free offer runs out, but really cant make my mind up about it. Currently using a en90 but owning a transit I need a good welder. Is it any good for around 4mm like it says or is that a load of ****? Will it do thin stuff like 08-1.0mm without blowing holes?
If its any good for thin stuff I might bite the bullet, buy it, sell the en90