I know, its a no no to most people, I am the same, well nearly always, but I was wondering if any of you have a 38mm 1.5 tap I could borrow for a one off clean up job. I am having to replace the lower ball joint on my 307 Peugeot and had a helleva time getting the old one out. The threads are/were in poor condition. I have tidied them up using a old joint with good threads into which I cut 4 slots to run down but I cannot get it to go the last eigth of an inch. I will promise it will be returned as soon as I have used it and quite happy to leave a deposit and obviously post and bear money will be given.