hi guys had go at tigging cast manifold flange with stainless pipe and filler rods
i thought erm it works was rather inpressed until it started colling and could hear what i think was heat crackes as i think it cooled too quick , i was advised to tap it with a small hammer to prevent this ,any thoughts advise , ps only a trail idea but looks like ill have to get a stainless flange instead
as i made a stainless manifold for my mk1 vr6t 4wd car quick engine shot here
i thought erm it works was rather inpressed until it started colling and could hear what i think was heat crackes as i think it cooled too quick , i was advised to tap it with a small hammer to prevent this ,any thoughts advise , ps only a trail idea but looks like ill have to get a stainless flange instead
as i made a stainless manifold for my mk1 vr6t 4wd car quick engine shot here