Rallymantony
New Member
- Messages
- 5
- Location
- Surrey, UK
Hi guys
New to the forum, looks great.
This has probably been asked a couple of thousand times before, but I'm looking to purchase a plasma cutter and wondered what peoples thoughts/experiences were?
The cutter will mainly be used for vehicle restoration and repairs, cutting 2m lengths of 1.5mm sheet steel, it will also be used for cutting quite tight curves on 4 - 6mm plate, no doubt I will find other uses for it but these will be the main uses.
Looking for single phase preferably and would be an advantage if it had its own compressor although this isn't essential.
Have a budget of around £1000.
Seen a nice Esab (I love my Esab welder) and also a a GYS, they both sound good but then they would wouldn't they?!
Thank you in advance guys.
New to the forum, looks great.
This has probably been asked a couple of thousand times before, but I'm looking to purchase a plasma cutter and wondered what peoples thoughts/experiences were?
The cutter will mainly be used for vehicle restoration and repairs, cutting 2m lengths of 1.5mm sheet steel, it will also be used for cutting quite tight curves on 4 - 6mm plate, no doubt I will find other uses for it but these will be the main uses.
Looking for single phase preferably and would be an advantage if it had its own compressor although this isn't essential.
Have a budget of around £1000.
Seen a nice Esab (I love my Esab welder) and also a a GYS, they both sound good but then they would wouldn't they?!
Thank you in advance guys.