Howdy Folks!
I know by searching these forums lately that electricity supplies have been covered a lot, but please just clarify it for a very green Bus-pass holder! I'm waiting for my Portamig 185 to arrive and I gather that a 16 Amp. supply is best. I'm going to run a couple of wall-mounted 16 Amp. sockets (blue) to where I'm most likely to be using the MIG. Is 16 Amps JUST enough, or is it completely adequate for the Portamig? At the C/U end should I run it from a 16 Amp. MCB or would 20 Amp. be better?
Thanks,
Tony.
I know by searching these forums lately that electricity supplies have been covered a lot, but please just clarify it for a very green Bus-pass holder! I'm waiting for my Portamig 185 to arrive and I gather that a 16 Amp. supply is best. I'm going to run a couple of wall-mounted 16 Amp. sockets (blue) to where I'm most likely to be using the MIG. Is 16 Amps JUST enough, or is it completely adequate for the Portamig? At the C/U end should I run it from a 16 Amp. MCB or would 20 Amp. be better?
Thanks,
Tony.