Power setting for my migmate 130 turbo

Hi i have just started welding and i have a migmate 130 turbo, however i have done some welding but i cant work out how the power settings work, so i was hoping that someone hon here could shed some light on it for me.



I know that the three white switched work the power settings but i cant work out how the different power setting are chosen.

Any help would be realy realy great.

Tom

The SIP manual isn't very clear at all. My reading is:

Positions of the three switches (left to right):
1 (lowest): down,up,down
2: down,up,up
3: down,down,either
4: Up,up,down
5: up,up,up
6 (highest): up,down,either

So high and low are course settings, and the min,med,max are fine control within those coarse settings, with the med/min button not having any effect unless the middle switch is not set on max.

You've done me their Malcolm with those settings.

Re

Thanks for that info malcolm it makes sence to me now, thansk again

Migmate 150N

malcolm said:

The SIP manual isn't very clear at all. My reading is:

Positions of the three switches (left to right):
1 (lowest): down,up,down
2: down,up,up
3: down,down,either
4: Up,up,down
5: up,up,up
6 (highest): up,down,either

So high and low are course settings, and the min,med,max are fine control within those coarse settings, with the med/min button not having any effect unless the middle switch is not set on max.

Click to expand...

I had also the same problem but thanks for the info guys, I have put a meter across mine as well so thought I would post the voltages up as well better to keep it all in one place even though its for a 150n.

I did these test on the min wire setting on a standard 240 Australian Outlet.

Low Min = 18.70v
Low Med = 20.60v
Low High = 23.00v

High Min = 26.70v
High Med = 30.40v
High High = 35.30v

I also tried using a modified 15m 15amp extension cord and it drooped all the above voltages down by .2v I am unsure how big a difference it would make during welding but thought I would try it anyway whilst I had the meter out.