Use sitting disc in an angle grinder , cutting along a clamped down straight edge cut the roller bar ( off pressure ) by the same amount and re drill the holes as needed
Have you put a water barrier .. bitumen paint ,lead sheet plastic or whatever between the blocks and the buildings wall to stop damp bridging over the damp proof course ?
When you see the heater tube and the tiny blue flame that heats the condensing tube it's not really surprising how little gas it take to run the fridge, likely less heat than a burning match
Yesterday Fizzy made magic smoke when he fired up his welder . At first he didn't see it as he was masked up about to carry on welding . I got him to stop within a second or so and the welder sent out enough smoke signals to tell the guys at the battle of little big horn to go home and not...
Water pump pliers they have longer arms
https://gsworkwear.com/products/draper-waterpump-pliers-240mm?variant=17234592333867&msclkid=7095769d5ee411cdc67110bba61faac1
Either weld the chuck key to a big lump of metal after taking it out the chuck or take it out and chuck it in a bucket of dirty oil or if there is one the cutting fluid tank.
Then tell them why it happened .
As an apprentice leaving the key in the chuck of the lathe or drill was a safety...
Use suspended inverted used milk bottles with your printed cap filled with a well diluted nutrient such as baby bio to run a mini drip tube to individual plants such as tomatoes or strawberry pants , consistent moisture ( not drowning ) is the secret to growing crops
Just clean it many times with WD 40 & a scotch brite green pan scrubber & soft cotton rags , it will allow you to familiarize yourself with the lathe and still have " The character of an old good working lathe .
Battery too discharged & sulphated up to take a charge from a normal charger , so it just gets hot . There are cheapish de-sulphating intelligent chargers that have all manner of different pulsed different wave forms that can resurrect a battery that had dropped below 9 volts but they rarely...
Put the small desiccant bag in the the cap inside a stubby vented screw capped tube ... lots of vitamin tablets ( not capsules ) have these sort of desiccant included caps .
Whilst your waiting for the new one to arrive virtually any domestic appliance 25 micro farad motor capacitor should be Ok to do a test run
When ordering the new capacitor ensure it is the same dimensions or very close and the same capacitance number in micro farads .
Ensure it is the...
Adapt the cap or the flange to take a proper sealing "O" ring and get hold of some of the small desiccant bags to keep any contained moisture off the rods ...... guess how I know this ? I used 44 mm sink waste pipes and 28 solvent welded flanges on the end of the cut to size pipes ( plus 50mm )...
Also very handy for sending long bubble wrapped fishing rods by carrier , I've just spent £138 on plastic soil pipe and two end caps with flanges like yours . IIRC the caps alone were £14 each three stirrup clamps with three 44 mm take off inserts made me cry .
That could be the base unit of a very nice Bonsai turn table ( profitable ?? ) All you need is a base ring 1/2 " on one side and at an inch on the opposite side it at an angled slope fit a plywood top covered in rubber sheet to stop th plant pots sliding off as you rotate the plant to work...
That would only carry the hydraulic lift pumps load , perhaps driving it flat out with a load being lifted at the same time would give a better result.
See if anyone local to you will 3D print them for you ???? That would be my line of attack if I wanted some robust cases . Or look on " Thingyverse " type sites to see who is doing them for a small fee.