Just got the adjusters fitted, had to modify the right side slightly as the nuts locking tabs weren't getting full engagement, quick trip to the workshop and milled out a pocket 3mm deep for the washer and all is good.
Makes adjusting the chain a breeze compared to the oem method, so very happy :)
Made most of the parts.
Stainless bolts.
the main slider parts.
One side has to be deeper at the clamping section than the other.
Fitted together.
Still have to bore/tap for the M5 dog point that will retain the bolts and also make the clamp plates, once that is done I will...
Just made this, simple test pattern from some 8mm 5083 to see if my measurements are correct before I machine the part out of some 2.5" x 2" x 150mm Aluminium as I don't have a lot left so don't want to waste it :D
Yesterday I was asked if I could repair a badly corroded part of an outboard.
It is not pretty but hopefully it will be ok.
Milled it flat(ish)
There were also two pinholes that ended up a bit larger, used the MIG as couldn't really get in to clean well enough for Tig. It is ugly but...