paul taylor
New Member
- Messages
- 4
- Location
- Raunds, uk
Hi All. I have made a pair of driveway gates from 60x30x3mm box mild steel. I have welded a 30x30x3mm angle iron to 1 of the uprights to act as a stop, I have only welded 1 side along it's edge as I thought this would be sufficent, but it has pulled the steel from straight by about 10mm over 1.8m in length. If I was to weld the other edge, will it pull it back straight or am I better off cutting the angle off & start again( (I guess by just removing the angle iron it won't straighten itself?)
Thanks in advance for all replies.
Paul.
Thanks in advance for all replies.
Paul.