Mark S
Member
- Messages
- 29
Hello out there.
I have a Sealey supermig 150 on co2, 0.6 wire. I am thinking of putting gauges or a flowmeter or both on my mig to see if I can get better looking welds. I don't want anything expensive but do need accuracy.
What would be the best setup? I would mainly be working with 3/4/5mm material what flowrate should I be going for as a starting point. Could I change up to 0.8 wire for the material I would be working with?
Thanks for any pointers inadvance.
I have a Sealey supermig 150 on co2, 0.6 wire. I am thinking of putting gauges or a flowmeter or both on my mig to see if I can get better looking welds. I don't want anything expensive but do need accuracy.
What would be the best setup? I would mainly be working with 3/4/5mm material what flowrate should I be going for as a starting point. Could I change up to 0.8 wire for the material I would be working with?
Thanks for any pointers inadvance.