Hey Guys,
Need some advice on a half decent tool under £200 (if possible) manual/hand bender perhaps, that will form a piece of stainless steel tubing to the following specs.
Stainless 316 tubing-
0.7mm-1.5mm wall
upto 12.7mm (1/2") OD (possibly even 15mm max)
20mm minimum radius
180degree maximum angle
If there is a tool that suits the above requirements please let me know. I will need to produce multiples so I appreciate my budget may not result in anything super quality but aslong as it will make clean bends for a while atleast.
cheers
David
Need some advice on a half decent tool under £200 (if possible) manual/hand bender perhaps, that will form a piece of stainless steel tubing to the following specs.
Stainless 316 tubing-
0.7mm-1.5mm wall
upto 12.7mm (1/2") OD (possibly even 15mm max)
20mm minimum radius
180degree maximum angle
If there is a tool that suits the above requirements please let me know. I will need to produce multiples so I appreciate my budget may not result in anything super quality but aslong as it will make clean bends for a while atleast.
cheers
David