Hi guys, got a cheap set of carbon oval race cans for my SP1 as they came off a bike that had been down, I've got the bits to sort out the damage to the can itself but the part I'm asking for info on is on the link pipe itself going from the can to the manifold/header, basically as the bike the cans were on went onto its side its dented and rashed up the link pipe, its not badly dented so looking to repair/restore rather than replace
now, what i was thinking of doing was using my air compressor to pressurize the pipe and then add some heat to the dent to push the worst of it out, only thing is i'm kinda stuck for idea's on what to plug 54mm pipe with that'll hold the pressure and be ok with a little bit of heat?
bear in mind my welder is broken at the minute so I cant do anything with that at the mo
now, what i was thinking of doing was using my air compressor to pressurize the pipe and then add some heat to the dent to push the worst of it out, only thing is i'm kinda stuck for idea's on what to plug 54mm pipe with that'll hold the pressure and be ok with a little bit of heat?
bear in mind my welder is broken at the minute so I cant do anything with that at the mo