Noods
Member
- Messages
- 979
- Location
- Ipswich
Hi..
One of those questions I guess when you only have limited machinery.
I need to cut an accurate hole in steel to enable to press fit a small ball bearing assm into ( not blind) my pillar drill only takes up to 13mm shank I have milling flute bits of the correct size being 26mm but the shanks are too big again to use.
No milling machine and no lathe either.. Any ideas what I can do.. I thought about one of those stepped cone shaped cutters but they will leave an undesired angle ???
Many thanks
One of those questions I guess when you only have limited machinery.
I need to cut an accurate hole in steel to enable to press fit a small ball bearing assm into ( not blind) my pillar drill only takes up to 13mm shank I have milling flute bits of the correct size being 26mm but the shanks are too big again to use.
No milling machine and no lathe either.. Any ideas what I can do.. I thought about one of those stepped cone shaped cutters but they will leave an undesired angle ???
Many thanks